CNCSimulator Pro

user guide
×
Menu
Index

12.1.37.3. Finishing

Lathe finishing operations are normally used to finish off a part after rough cutting it.
 
Just as with Rough cutting, you need a contour and you need to add two points to the layer that defines the "operation window". If you are not sure on how to do that, please read about it under roughing.
 
 
 
Number of passes Here you can enter the number of finishing passes you want to do.
 
Start Clearance If you use more than one finishing pass, you need to tell at what clearance you want to do the first pass.
 
Final Clearance If you want to leave material after the final cut, enter the value here.